Instructions

Welcome to the TKO Owner's Club

This board was born out of both our love for the water and extreme water sports. It was crafted without compromise to be the best that our team of engineers and designers could deliver. Through countless iterations of everything from the hull to the controllers, we’ve kept refining the Type - 001 to be the jetboard that we wanted for ourselves– with the ideal balance of power, control and agility; One that we could rip through the waves while being gentle enough for our kids to learn on. Pure electric, zero emissions.
We hope that you will enjoy this board as much as we do, from the big surf to placid lakes and everything in-between. Have fun and don’t stop riding!

What to Wear
  • A DOT/SNELL/ANSI approved helmet
  • A Coast Guard/Class II approved life jacket/ impact vest
  • A rash guard and close-fitting legwear - Never ride the jetboard in loose attire.
Charging the Battery
  • Lower the Jetboard Battery into the charging cradle, aligning the female connector on the battery with the male connector on the cradle. (diagram 1, 2 in the Manual)
  • Attach the magnetic head of the Power Leash onto the board. (diagram 3,4 in the Manual)
  • Plug the charger unit into a power socket and power on the charger. The indicator lights on the TKO charger reflect the charging status. (diagram 5)
  • The Jetboard Battery usually takes about 2 hours to charge fully on a domestic power supply.
  • Important: Ensure that your wall socket is able to supply at least 10A (220V) or 15A (110V), according to the voltage specification on the charger.
Charging the Wireless Controller
  • The Wireless Controller battery is charged via a magnetic connector.
  • Bring the charging head of the cable in-line with the connector at the top rear of the controller. It should snap into place. (diagram 6, 7 in the manual)
  • Plug the other end of the cable into a suitable USB-A socket. Charging should start automatically.
  • The battery is fully charged when the screen shows 100%. (diagram 8)
  • Important: A USB socket that supplies 5V and 2A is required.
Maintaining the Board
  • Rinse and dry your jetboard, battery and wireless remote with fresh water after use.
  • DO NOT LEAVE YOUR JETBOARD, BATTERY OR WIRELESS CONTROLLER FOR EXTENDED PERIODS IN THE SUN. DRY YOUR EQUIPMENT IN THE SHADE.
  • Charge your jetboard battery and remote fully before putting it into storage.
Warning
  • As the use of this jetboard is an extreme activity, all riders should seek appropriate medical advice before the use of this product.
  • Only able swimmers should use this jetboard as there will be occasions where the rider may be separated from the board in use.
  • Keep your hands and feet away from all moving parts on this jetboard - Contact while in use may lead to serious injury or death.
  • Riding this board assumes that you are aware of local regulations regarding the use and operation of a watercraft of this nature.
  • Ride within your skill level and do not perform tricks or stunts on this jetboard as you could injure yourself or others.
  • Never attempt to remove or insert the Jetboard Battery in the water.
  • Never attempt to remove or insert the Jetboard Battery in the water.
  • Do not operate the jetboard in situations where debris can be ingested into the drivetrain as this can cause damage to the board and injure those around.
  • Do not modify this craft and its associated accessories in any way. Only use the supplied TKO chargers with the jetboard battery and remote controller. Non-compliance will void your warranty and may lead to incidents that can result in serious injury or death.
  • Do not use this watercraft under the influence of alcohol or drugs.
  • Do not use this watercraft if you are pregnant or suspect that you are.
  • Never attempt to remove or insert the Jetboard Battery in the water.

Tutorials

Manual